Is 50 × 70 cm the same as A2?
No. A2 is 42 × 59.4 cm (420 × 594 mm). A 50 × 70 cm poster is 8 cm wider and 10.6 cm taller. An A2 print fits inside a 50 × 70 cm insert, but not edge to edge; a mat fills the space around it.
| Size | Centimetres | Millimetres |
|---|---|---|
| A2 paper | 42 × 59.4 | 420 × 594 |
| 50 × 70 cm poster | 50 × 70 | 500 × 700 |
Paper dimensions: PaperSizes.org A-series table, checked 28 October 2026. In inches, A2 is about 16.5 × 23.4 and 50 × 70 cm is about 19.7 × 27.6. The differences above are calculated from the millimetre dimensions.
Calculate a mat for A2 in a 50 × 70 cm frame →
Will an A2 print fit a 50 × 70 cm frame?
Yes, with space around it. Centred without overlap, the gap is 40 mm at each side and 53 mm above and below. Unlike A3 in a 40 × 50 cm frame, the wider gap here is at the top and bottom; on a portrait poster the extra space sits above and below the image.
Large prints are more likely to ripple or slide behind glass. A mat, hinging tape or a backing board that holds the print flat matters more at this size than for a small photo. Those materials are outside what this calculator assesses.
A custom mat example
With a planning overlap of 3 mm on each edge: 420 − 6 = 414 mm and 594 − 6 = 588 mm. Centred in a 500 × 700 mm board, the 414 × 588 mm window leaves 43 mm at each side and 56 mm at top and bottom.
| Measurement | Size |
|---|---|
| A2 sheet | 420 × 594 |
| Mat outside and frame insert | 500 × 700 |
| Actual cut window | 414 × 588 |
| Left and right border | 43 each |
| Top and bottom border | 56 each |
Posters are not always exactly A2
Many posters are sold as “A2” or “50 × 70” without the exact trimmed size. Measure the sheet itself before ordering a mat: a few millimetres difference changes how much of the image the overlap covers.
Open this example in the calculator →
Related measuring guides
- Is 40 × 50 cm A3? A3 in a 40 × 50 cm frame
- Is 30 × 40 cm A4? A4 in a 30 × 40 cm frame
- Art size versus mat opening when ordering a frame
Overlap reference: Frame It Easy’s explanation, checked 26 October 2026; that seller’s own default is ¼ inch per edge, while the examples here use 3 mm or ⅛ inch as planning values. These worked examples are independent calculations, not confirmation of a particular product’s fit.